When needing to lighten sheet metal panels without weakening the panel, a punch and flare tool is the thing to use.....This also works well if you have to punch a hole through a firewall and have a nice clean flared or beaded..... . This also can provide that custom touch to your metal panel......These dies can punch and flare ,or just punch up to 16 guage steel...... All you do is drill a pilot hole apply the tool and tighten ,or you can use our press (see our press thumbnail for details)......These are available in a punch and flare or a punch and bead die...... Sizes available are 1, 1.25, 1.5, 1.75, 2, 2.5, and 3 inch in the bead.The flare sizes are .5, .66, .75, 1, 1.5, 1.75, 2, and2.5 inches....... To save money these are available in sets. These are all made in the USA...........CALL FOR PRICING
